Stran 2 od 3
Re: Manual Shifting Engine
Objavljeno: Po Feb 28, 2011 7:55 pm
Napisal/-a pomartin
i ensure you that it is almost none of work
al you have to do is cut two appropriate pieces of metal, drill 2 holes in each of them, and then adjust the exhaust "knee" (cutting and welding)- IF NECESARY, and ofcoure make a neu knee for carburator (cutting, drilling and welding).
Re: Manual Shifting Engine
Objavljeno: Po Feb 28, 2011 7:57 pm
Napisal/-a apn6s freek
30 minutes and itss done not big deal
Re: Manual Shifting Engine
Objavljeno: Po Feb 28, 2011 8:00 pm
Napisal/-a MichielWolthaus
If that is al, it would be great.
But does the front gear allign with the rear gear?
And don't I have to cut somewhere in the frame (it seems not, but i want to be sure)
Re: Manual Shifting Engine
Objavljeno: Po Feb 28, 2011 8:01 pm
Napisal/-a MichielWolthaus
apn6s freek napisal/-a:30 minutes and itss done not big deal
Then every smart kid in the Netherlands would have suchs an engine
Re: Manual Shifting Engine
Objavljeno: Po Feb 28, 2011 8:03 pm
Napisal/-a apn6s freek
MichielWolthaus napisal/-a:apn6s freek napisal/-a:30 minutes and itss done not big deal
Then every smart kid in the Netherlands would have suchs an engine
hehe itss realy not a big deal
no need to cut frame
Re: Manual Shifting Engine
Objavljeno: Po Feb 28, 2011 8:03 pm
Napisal/-a pomartin
MichielWolthaus napisal/-a:If that is al, it would be great.
But does the front gear allign with the rear gear?
And don't I have to cut somewhere in the frame (it seems not, but i want to be sure)
i think there is no need to adjust the frame becouse of the gears
Re: Manual Shifting Engine
Objavljeno: Po Feb 28, 2011 8:04 pm
Napisal/-a MichielWolthaus
That would be nice.
Now I have to try to find such an engine in the Netherlands.
That will probably be the hardest part
Re: Manual Shifting Engine
Objavljeno: Če Mar 03, 2011 5:14 pm
Napisal/-a MichielWolthaus
I found out that exhausts for Tomos A3 fit on a manuel engine, so I don't need to change anything at the exhaust
Re: Manual Shifting Engine
Objavljeno: Po Maj 02, 2011 8:30 pm
Napisal/-a MichielWolthaus
Still thinking about building an manual shifting engine.
But what are the pro's and cons of putting an A35 cilinder onto a manual shifting engine?
The only pro I can think of is less fuel use.
Re: Manual Shifting Engine
Objavljeno: Po Maj 02, 2011 8:35 pm
Napisal/-a pomartin
if you want to put a35 cilinder on manual shift engine, you have to make its "neck" a bit thinner.. thats cons