U also should get better throtle response, cause a35 cilinder has a reed valve.MichielWolthaus napisal/-a:Still thinking about building an manual shifting engine.
But what are the pro's and cons of putting an A35 cilinder onto a manual shifting engine?
The only pro I can think of is less fuel use.
Manual Shifting Engine
Re: Manual Shifting Engine
- MichielWolthaus
- batzajla
- Prispevkov: 35
- Pridružen: Po Feb 28, 2011 4:48 pm
- Kraj: Brakel, The Netherlands
Re: Manual Shifting Engine
The 'neck' of the cilinder or the 'neck' of the engine?
- MichielWolthaus
- batzajla
- Prispevkov: 35
- Pridružen: Po Feb 28, 2011 4:48 pm
- Kraj: Brakel, The Netherlands
Re: Manual Shifting Engine
Allright, another question.
Has an stock membrame-cilinder enough torque/power to ride in the 4th gear of an manual shifting engine?
If not, what do I need to change to get enough torque/power to ride in the 4the gear?
I thought about making the exhaust port a little wider, or even make the tranferports higher(less rpm).
Hope you guys got answers to this, because in the Netherlands almost nobody knows something about the manual shifting engines.
Has an stock membrame-cilinder enough torque/power to ride in the 4th gear of an manual shifting engine?
If not, what do I need to change to get enough torque/power to ride in the 4the gear?
I thought about making the exhaust port a little wider, or even make the tranferports higher(less rpm).
Hope you guys got answers to this, because in the Netherlands almost nobody knows something about the manual shifting engines.
Re: Manual Shifting Engine
yes it hasHas an stock membrame-cilinder enough torque/power to ride in the 4th gear of an manual shifting engine?
![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
but if you want even better performance, you will have to make some changes. i recommend that you found some portmap- here on our forum you can find junior portmap- and copy it on your cylinder.
stock membrame-cilinder have very good potential for tunning, but you need to be very patient becouse there is quite much material to whet.
bol star bol nor!
Re: Manual Shifting Engine
U should get a better perfomance just by widening the exhaust port like u already set. But if u will rise the transfer port u will decrease the power in low rpm and increase the power in high rpm. Explanation: When the piston is moving faster, the transfer ports must be opened a bit longer then in stock cyilinder. So if u rise the port, moped wont go well in lower rpm because mixture will flood the engine, but in higher rpm the moped should go very well. But another fact is, that u cant rise just transfer port, but also the exhaust port and inlet port that must not be risen but lowered.MichielWolthaus napisal/-a:Allright, another question.
Has an stock membrame-cilinder enough torque/power to ride in the 4th gear of an manual shifting engine?
If not, what do I need to change to get enough torque/power to ride in the 4the gear?
I thought about making the exhaust port a little wider, or even make the tranferports higher(less rpm).
Hope you guys got answers to this, because in the Netherlands almost nobody knows something about the manual shifting engines.
I hope i helped u a bit,
Regards, Simon
Re: Manual Shifting Engine
or simply read the graham bell 2 stroke performacne tuning book ![Smile :)](./images/smilies/icon_e_smile.gif)
http://file.si/pfiles/173944/a-graham-b ... troke-.pdf
![Smile :)](./images/smilies/icon_e_smile.gif)
http://file.si/pfiles/173944/a-graham-b ... troke-.pdf